Navigate
WLA Support
  • Register

  • or
  • Login
    Need a password reminder?
or
Contact Us
  • Knowledgebase Read help articles
  • News News & updates
  • Downloads Browse our downloads
  • Contact Us We are here to help
  • Portal
  • Knowledgebase
  • General
  • Initial Setup Instructions for AdvancedMD
Subscribe Download PDF

Initial Setup Instructions for AdvancedMD

Andrew Smith
2014-07-16
in General

Initial Setup Instructions for AdvancedMD:

 

  1. Open Internet Explorer
  2. Click on “Tools”. If the menu is not showing, press Alt key.
  3. Click “Internet Options”.
  4. Select the “Security” Tab at the top.
  5. Click once on the green check labeled “Trusted Sites”.
  6. Click the “Sites” button below that.
  7. Under “Add this website to this zone:”, type:  *.advancedmd.com and press Enter.
    Repeat this step twice, adding *.wlaapps.com  and *.warelanghorne.com
  8. Uncheck the box labeled “Require server verification” if it is already checked.
  9. Click “Close”.
  10. Click on “Custom level”.
  11. At the bottom, where it says “Reset custom settings”, select “Low” and press the “Reset” button.
  12. When asked if you are sure you want to make this change, click “Yes”.
  13. Click “OK” and then “OK” again to get back to Internet Explorer.
  14. Again, click on “Tools”.
  15. Select “Pop Up Blocker” and then “Pop Up Blocker Settings”.
  16. Under “Address of website to allow:”, type *.advancedmd.com and press Enter.
    Repeat this step twice, adding  *.wlaapps.com  and *.warelanghorne.com
  17. Click “Close”.

 Set up for AdvancedMD is now complete, in Internet Explorer go to the following website:

                http://www.wlaapps.com/wlalogin

From here, you must log in using your username, password, and key.  You must log into the AdvancedMD PM before you can log into EHR, so make sure to click “PracticeMgmt” here.   You may see a box asking you to install “Controls”.  Click “Install Controls” and then click “Yes” or “OK ” for any security questions (there may be 7 of them).  Once complete, you can now log into EHR.

Rate the quality of this page

This page was helpful :) :( This page was not helpful

6 of 11 people found this page helpful


Quick Jump
  • WLA Support
  • Knowledgebase
  • News
  • Downloads
  • Contact Us
Top
Helpdesk software provided by Deskpro